Tax, title, license (unless itemized above) are extra.
In extreme cases, the leak can get so bad internally that it can actually Hydro-lock (when an engine fills with so much liquid that the pistons cannot move up in their bore).
10) Remove Fuel Rail with injectors.
To remove them, squeeze in on the bottom of the clips, then pull up on the fuel line.It should NOT require any prying to get it loose.There is a bracket which connects the throttle body to the cylinder head, this little bracket blocks access to one of the throttle body nuts.After these two steps, you must gain access to the intake manifold by removing some things that are in your way.Written by Joe.It is crucial that you remove all of this coolant, use Paper towels or old rags to soak it all.Not available with special finance, lease and some other offers.TIP: There is a bolt which is hard to see just below the belt idler pulley.Sorry images have been lost, View video Instructions, remove the air 9 gifts of the holy spirit pdf filter housing.For Fishers Chevrolet customers, our knowledgeable staff will answer all the questions they may have.7) Remove the 6 Fuel Injector electrical plugs, (Squeeze in on the metal locks and pull up) Remove the three electrical connectors going to the throttle body.Clean the gasket mating surface on the lower intake manifold.You can leave the throttle cables attached to the throttle body, and just position the entire assembly aside.To learn more, stop by our dealership near Anderson, IN today!16) Reinstall all accessories and wiring, and fuel rail in the reverse order of removal.Once you remove those four 10mm nuts, carefully wiggle and pull upwards on the fuel rail, and the injectors will unseat themselves from the lower intake manifold, and the whole fuel rail will come out.
The car had stalled on him, and would not turn over at all, acting like the engine was seized.
Parts List for the GM 3800 Intake Manifold.




Instructional Video Now Available: Before I start, here are the exact vehicles affected by this leak: Pontiac Bonnville.8L Chevy Monte Carlo.8L Chevy Impala.8L Buick Lesabre.8L Buick Regal.8L Buick Park Avenue.8L Buick Riviera.8L Olds Regency.8L Oldsmobile Delta.With our quality of service and quantity of cars and trucks you'll see why buyers make the quick trip down the road to our Fishers auto source, Hare Chevrolet!(Peel back the top of the hose, then work around until the whole thing oye happy gifts comes loose) Disconnect the plug going into the intake hose, and remove whole assembly from car.Before you tear into it, there are two important steps, 1) disconnect the negative battery terminal 2) Drain any engine coolant that may still be in the car (there is a small drain near the bottom of the radiator).18) Start car and let idle for a while, check for any coolant leaks, carefully watch your temperature gage to make sure no overheating takes place.New Used Vehicles for Fishers Anderson, IN Shoppers at Hare Chevrolet.Refill the coolant system.Install six new spark plugs and you are good.12) Remove all of the upper intake manifold bolts, and remove the intake from the car.17) important step: If you saw ANY coolant at all inside the intake manifold upon removal, you must replace the spark plugs.Which is simple to do 17a) Remove all six spark plugs, and turn the engine over (pretend youre starting it) for at least 30 seconds.
My trick is to remove the Bracket-to-throttle body bolt, then carefully pry the bracket back until you have enough access to reach the nut with a deep 10mm socket and extension.



Tax, title, license and dealer fees (unless itemized above) are extra.
At this point, you should have clear access to the entire upper intake manifold.
One of the first signs of the intake manifold failure is coolant loss, these intakes can leak internally into the engine, or externally near the thermostat housing.

[L_RANDNUM-10-999]